markus.p Geschrieben November 26, 2021 at 19:10 Geschrieben November 26, 2021 at 19:10 Hello, I have a new Warp2 Pro charger with FW 1.1.0. The LAN Connection interrupts always after a couple of minutes . Device disappears and can not be accessed via LAN ip address. WLAN works fine. A reconnection of LAN cable does not help. The box needs always to be disconnected from power for a short time. LAN configuration is DHCP. FritzBox uses always same ip address. Markus Zitieren
rtrbt Geschrieben November 29, 2021 at 09:51 Geschrieben November 29, 2021 at 09:51 Hi, On 11/26/2021 at 8:10 PM, markus.p said: WLAN works fine. If you can still reach the web interface over WLAN when the LAN connection is interrupted, please download a debug report (System -> Event-Log -> Download debug report and event log) and post it here. Zitieren
markus.p Geschrieben November 29, 2021 at 20:39 Autor Geschrieben November 29, 2021 at 20:39 Hello, I do not want to attach the log file to this chat since there are some NW details inside. Can you provide me a email address for log file upload. What I can see as last 2 lines within the log file are: 12127 MQTT: Connected to broker. 95633 httpd_ws_recv_frame failed to get frame len with 259 The rest looks Ok. There are not any errors. Markus Zitieren
markus.p Geschrieben November 29, 2021 at 20:46 Autor Geschrieben November 29, 2021 at 20:46 Status Screen: "Verbinde" stays all the time until power reset cycle Zitieren
rtrbt Geschrieben November 30, 2021 at 09:54 Geschrieben November 30, 2021 at 09:54 11 hours ago, markus.p said: Can you provide me a email address for log file upload. Sure, please send the log to erik@tinkerforge.com. Zitieren
adr1an0 Geschrieben April 4, 2022 at 21:11 Geschrieben April 4, 2022 at 21:11 I have the same problem or very similar problem. I cannot connect to the Webserver via Ethernet. Log also showing httpd_ws_recv_frame failed to get frame len with 259 Is there a official solution for that? Thank you, Adriano Zitieren
rtrbt Geschrieben April 5, 2022 at 06:59 Geschrieben April 5, 2022 at 06:59 Do you also get "Verbinde" or "Connecting" as LAN/ethernet status? In this case the problem is usually with the ethernet cable. Also we've had one case where the router that the charger was connected to had a non-working ethernet port. The log message indicates that a WebSocket frame could not be sent, however if you can't load the Webinterface at all, there is no WebSocket connection. So this is likely a message generated when you disconnect from the chargers WiFi access point. Zitieren
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.